Gear Generator to Autodesk Inventor

Intro: Gear Generator to Autodesk Inventor

Here is how we take gears from the program Gear Generator by WoodGears into Autodesk Inventor and match it with a Tetrix hole pattern.

Also, you can download the FTC Kit of Parts here.

Share

    Recommendations

    • Audio Contest 2018

      Audio Contest 2018
    • Metalworking Contest

      Metalworking Contest
    • Furniture Contest 2018

      Furniture Contest 2018

    Discussions

    0
    None
    Numbuh1

    4 years ago on Introduction

    Thanks! I was about to go ahead and make gears by hand in Inventor, but this is so much easier:D