Glue Prank

Introduction: Glue Prank

This is one of my most favorite pranks ever. You can substitute water in for glue if you would like. Happy pranking!!!!:):):)

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Materials

Get some tape, glue, and some thread.

Step 2: Step 2

Unscrew the cap of the glue. And then make a tape donut and stick it to the back of the glue bottle.

Step 3: Step 3

Cut 4-2 ft pieces of thread and tape them to the front of your glue bottle one at a time. Cut the thread so that all 4 of them are equal.

Step 4: Step 4

Tape the ends of all the thread pieces to the corner of a door. Then tape the glue bottle to the wall above the door like in the picture. You can add more tape to keep the glue bottle up if needed.

Step 5: The Prank

Now just sit back and relax and wait for your prank victim to get soaked with glue the second they walk through the door!!!:):) if you liked this prank please favorite and vote!!!:):) thank you so much!!!:):)

UP! Contest

Participated in the
UP! Contest

April Fools' Contest

Participated in the
April Fools' Contest

Be the First to Share

    Recommendations

    • Cardboard Speed Challenge

      Cardboard Speed Challenge
    • Indoor Plants Challenge

      Indoor Plants Challenge
    • Sculpting Challenge

      Sculpting Challenge

    3 Discussions

    0
    CreativeGeek
    CreativeGeek

    6 years ago on Step 5

    Now had that been about three colors of poster paint that the string was tied to all at the same time, in addition, if the glue was swapped for white instead of clear... X3

    0
    kaitielaven
    kaitielaven

    7 years ago

    Considering the velocity of glue, I don't think the glue would have time to dump out when falling, most likely it would just hurt.