GoPro Gimbal

This instructable was created in fulfillment of the project requirement of the Makecourse at the University of South Florida (www.makecourse.com)

Step 1: Get the Parts

  • Arduino uno/nano
  • 2 micro servo motors
  • 9v battery
  • MPU6050 gyro sensor

Step 2: Write the Code

Watch the video for a full commented video about the code

Step 3: Design the Parts

Using a 3d CAD program like solidworks is great for this.

Step 4: Set Up the Circuits

Step 5: Step 5: Put Everything Together

Share

    Recommendations

    • Sweet Treats Challenge

      Sweet Treats Challenge
    • Epilog X Contest

      Epilog X Contest
    • Paper Contest

      Paper Contest

    Discussions