GoPro 3D Print Zip Tie Mount

Published

Introduction: GoPro 3D Print Zip Tie Mount

This part modifies an existing GoPro mount to turn it into a multi-functional zip tie mount. 

Step 1: Unscrew the Bottom

There are three screws on the bottom of the mount. Unscrew all three of these and remove the bottom plate. 

Step 2: Mount to Printed Part.

After you've printed the part place it on the bottom of the mount. Screw the three screws back in. Tah dah! 

Share

    Recommendations

    • Water Contest

      Water Contest
    • Clocks Contest

      Clocks Contest
    • Creative Misuse Contest

      Creative Misuse Contest

    2 Discussions

    Hello! These instructions are great. Would it be okay if I featured them on my blog, goproattachments .com?