Goldeneye 007 Proximity Mine 3D Print PIR




About: I am a college student; I enjoy hacking electronics and DIY projects

Goldeneye 007 Proximity Mine 3D Print that really works! ... well not in the exploding fashion, but will have the fun blinking lights and senses when someone is within proximity.. of the "mine".

After being Inspired by one of my favorite games of all time, Goldeneye 007 (N64), the PIR video by John Park, and the MAKERBOT Contest, I came up with the idea of combining one of Goldeneye's weapons with the PIR sensor circuit, and the result was this "PIR Proximity Mine."  The Center "bulb" is the PIR sensor . The 4 red Leds surrounding the PIR, (They should actually be GREEN) are fitted into holes cut for 5mm LEDs.  Forget those boring square motion sensors in your house, Imagine having this cool/intimidating sensor installed on your wall! The 5mm LED's can be power or status lights of how when movement is detected.



    • Trash to Treasure

      Trash to Treasure
    • Tape Contest

      Tape Contest
    • Arduino Contest 2019

      Arduino Contest 2019

    2 Discussions


    6 years ago on Introduction

    Cool. I need to figure out how to modify this to actually blow up (and still be reusable).

    Jeff Haas

    6 years ago on Introduction

    Very cool!

    Do you have video of how it works? And a schematic of the circuit?