A skateboard that can be placed vertically
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: Gy1
board is stretched from a sketch created with fitted curves and straight lines.Then the edges and corners of the plate model were modified to make the plate appear less obtrusive.
Step 2: Gy2
connecting part between the plate and the shaft was also mainly stretched and modified.
Step 3: Gy3
folding mechanism establishes two vertical plates and combines one of them with the plate of the slide plate.
Step 4: Gy4
oth plates have a hole at one end and a
connecting shaft is used to connect them. The folding mechanism is completed