Introduction: H.S.S.R. V2 (Heavy Support Splodie Rifle).
(I'am from holland so my english isn't always that good :P)
Welcome to my 1st instructable. In this instructable you'll see how the HSSR is made.
The HSSR shoots splodies, with a rang of 30-50 ft (depends rubberbands). The gun is bolt-action, so it has to be cocked every time you want to fire. It doesnt has a hopper, so you also have to load it every time you want to fire. The gun fires a lot of diffirent splodies but I prefer the red lenghth splodies.
I hope this instructable is clear enough to build it, if you have any comment or tip; Plz tell me.
EXTRA: you can add some grey connectors to the side of the gun to hold splodies.
WARNING: I'm not responsible for any damage to urself, your house, your cat. So plz dont shoot at animals or people (or expensive windows:P:P:P).
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: Front Piece (barrel and Most of the Mechanism).
This instructable excits out of 7 steps:
- front piece
- middel piece
- top piece
- complete assembley and the rubber bands
- "lock and load" shooting the damn thing
just follow instructions on photos.
Step 2: Middle Piece
making the middle piece, includes grip and trigger.
Just follow instructions on the photos
Step 3: Stock Piece
this is an easy piece,
just follow the instructions on the photos again ><
Step 4: Top Piece
very short step
Step 5: Complete Assembly and Rubber Bands
putting it al together
Step 6: Firing It
Ok this is how it works:
You make a splodie, pull back the bolt, lock the bolt, put in a splodie ( make sure it is between the to connector things), and fire it.
Finaly... I made my 1st instructable, It took some time (bout 2,5 hours...) And it was pretty boring to do, but worth it.