Introduction: HOUSE 3d Print (without Support)
Here is my model "House"
- I modeled this house with 3dsoftware,printed with a printer3d dagoma discovery 200
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: Modeling
Modeling: modeling using 3d software, model in one part, exported in STL format
Step 2: 3D PRINTING
Printed with dagoma discovery 200 with these parameters:
Y: 60.65mm Z: 100 mmX: 83.28 mm
Printing parameters: layer thickness: 0.20mm time: 5h14min Filling: full Support: NO.
The interior of the house is full.and the barries on the edge of the models support the printing. In this way, it did not need support to print the model.
Step 3: link