HOW TO MAKE F-15 EAGLE PAPER PLANE

Introduction: HOW TO MAKE F-15 EAGLE PAPER PLANE

About: i'm just a kid that likes to recycle, destruction, mayhem, cars, bikes, rockets, and food.I live in indonesia.

This aircraft is a great choice for you who are looking for a paper plane that go far and fast yet stable, and cool looking too.This plane fly pretty much like skyhunter paper plane by origamiairenforcer, but this plane is easier to make.When I throw this paper plane, this paper plane go 30 ft with ease.This aircraft is good for long range battle, air time battle, and speed battle.

.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Materials

Required:
1 Piece of 8.5 by 11 inch paper
Tape
Optional:
Pencil
Scissors (for modifications only)

Step 2: Step 1 Base Folding

print the pdf (don't mine the white part on the end when it's printed but don't cut it), fold the paper in half along it's length.Then, fold the top corners inward to the center line.Fold the top corners to the bottom edge.

Step 3: Step 2 Nose Folding

Fold the triangle section upward. Bring the sloping edge to the center line and crease only upper part of the folding line 3(A to B). While holding point C in place, sweep a finger under D and pull flap outward. Flatten it. Repeat step 3 and 4 on right side. Make sure both wings have the same sweep angle. Lift edge A and bring out the triangle corner of the middle layer. This part will become the canopy of the fighter jet.Flip the triangle section to the left side. Make the canopy of the fighter jet by valley folding the triangle section along line 6 and 7.

Step 4: Step 3 Wing Folding

fold it in half.Fold both wings 3/4 inches down and also fold 3/4 inches up for the winglets.And you also can fold the trailing edge form better lift.

Step 5: Step 4 Taping

This aircraft only need 2 tape. first is at the rear and second is at the nose of it's fuselage

Step 6: Step 5 How to Throw

Now fly this baby in the air.Throw it at a 30-40 degree angle with a fast throw (like a dart).

Step 7: Step 6 Modification

print the pdf (don't mine the white part on the end when it's printed but don't cut it), fold it, and cut it according the lines.fold thhe rear according the line and also the 2 winglets.

Be the First to Share

    Recommendations

    • Indoor Plants Challenge

      Indoor Plants Challenge
    • Trash to Treasure Contest

      Trash to Treasure Contest
    • Sculpting Challenge

      Sculpting Challenge

    2 Discussions

    0
    gundar-nimble

    2 words.....un-believable....it flew so far,long time but not too fast...