HOW TO MAKE a USB LED!

Introduction: HOW TO MAKE a USB LED!

About: Your one stop place for electronics tutorials, components and services!

Ever wanted to make an inexpensive light or a cheap nightlight for the kids here's how-

All You Need Is-

Hot Glue And Gun
Wire
Old USB Head
Solder and soldering iron
Led
100k Ohm Resistor!

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1:

First snip the resistor so 5mm is left on each end.
Then do the same with the led but just leave a little more on one side indicating the positive.

Step 2:

Now start soldering the resistor and the wire on the 2 ends of the USB and the led on the end of that!

Step 3:

Now you just give it a glue and touch up,
Then plug it in and... LET THERE BE LIGHT!

Thanks For The Attention!
Like, Comment and Follow Me

Want More?

Go to jackshow2s.weebly.com

Be the First to Share

    Recommendations

    • Backyard Contest

      Backyard Contest
    • Silly Hats Speed Challenge

      Silly Hats Speed Challenge
    • Arduino Contest 2020

      Arduino Contest 2020

    Discussions