We had a carver come to town and he showed me how to carve a spoon and now I'm showing you.
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: Materials
The only three things I needed were
- card board
- a carving knife (curved tip optional)
- a piece of wood (I used alder)
Sorry, I thought to make my Instructable after I started carving
so, I don't have the block of wood but i do have the dimensions.
Step 2: Drawing
Draw the spoon on to your block of would include all lines, also draw the template on the the back of the spoon. Sorry, still an amateur.
Step 3: Carving
After the templates drawn on the spoon, start carving off chips/shavings until you reach the line.
Step 4: Rounding
Make sure to redraw your template on every time it fades away. When rounding, shave off the edges until its round and on the top half of the dotted line. Using the dotted center line, carve toward the tip of the spoon and then towards the handle on the other side of the dotted center line.
Step 5: Hollowing
carve out the center of the spoon spoon making each cut go in a different direction. carve until you have a deepness of you liking
Step 6: Sanding (optional)
you have to let it dry fully before you can sand.
Step 7: Your Done
thanks for reading my instructable, sorry if it was hard to understand.
Also i would really like your vote in the wood working contest
i would like to give William, (gamaash his tsimsean name.) credit for this project.
his carving page on Facebook is Ravendancer Creations
Participated in the