Introduction: Hard Drive Necklace
This is my hard drive necklace. I hope you like my design!
Pretty simple hope you make one too. Make sure and post me a picture when you are done
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: Disassemble Your Hard Drive and Remove the Parts
All you gotta do is get a star bit or phillips head to open a hard drive, the get you parts out and begin !
Step 2: Main Piece
Take you spindle from the hard drive and get you screw driver and tap it on the back till the top pops off.
Step 3: Assemble Pieces
Take your parts that you scavenged and piece together your design. I used a little wire to put it together through the holes already there.
Step 4: Head Piece
Do the same with the wire and add the heads to the piece you have. You should end up with this
Step 5: Add the Necklace
Take the wire, string or cord and add it to finish your necklace.
The holes are already there!
I hope you enjoy and please vote for me! thx for looking!