Headphone Hanger From CD/DVD Spindle

Introduction: Headphone Hanger From CD/DVD Spindle

My inspiration for this is from this Instructable: https://www.instructables.com/id/headphone-holder/ Great idea, but I don't know how long the duct tape idea would hold and it probably would rip the finish off of my wooden desk upon removal. This is my first Instructable. Any comments/criticisms will be appreciated.

Step 1: Screw Washer to Post

I used a 25 DVD holder for this and using a screw attached it to the end of the post.

Step 2: Bend Coat Hanger

Then I took a piece of a coat hanger and bent it so it would hang on my desk drawer and the loop would fit around the flange on the DVD holder.

Step 3: Attach to Base

I had to cut out a little bit of plastic from around the flange and the lip that goes around the base.

Step 4: Hang on Drawer

Here's how the hooks look hanging over the drawer

Step 5: Done!

A convenient place to keep your headphones within reach and off your desk and not under or in the way of stuff in your desk drawers.

Be the First to Share

    Recommendations

    • Pocket-Sized Speed Challenge

      Pocket-Sized Speed Challenge
    • Audio Challenge 2020

      Audio Challenge 2020
    • Maps Challenge

      Maps Challenge

    Discussions

    0
    Scatmanbrandt
    Scatmanbrandt

    9 years ago on Step 5

    This is a good idea. I have a headset I use for gaming but when it's not in use it's just sitting on my desk, and I have plenty of those spindles left.