Headphone Holder

7,983

12

3

This instructable will show you how to make a headphone holder using only-
-Scissors
-A Piece of Cardboard
-Pen/Pencil/Sharpie
This is an easy project and should only take a couple of minutes.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Step 1

First, draw this shape on the piece of cardboard.

Step 2: Step 2

Cut out the shape.

Step 3: Step 3

Cut a small strip of cardboard out on each side of the shape and cut out a small hole. You may want to put a hole at the end of each of the openings on the side for the cord to slip in to (not shown).

Step 4: Step 4

Put the auxiliary plug into the hole, wrap the cord around the cardboard and slide the cords into the opening (Make the openings smaller than in the picture or otherwise the cord will come out)

Pocket-Sized Contest

Participated in the
Pocket-Sized Contest

Share

    Recommendations

    • Indoor Lighting Contest

      Indoor Lighting Contest
    • Make It Fly Challenge

      Make It Fly Challenge
    • Growing Beyond Earth Maker Contest

      Growing Beyond Earth Maker Contest

    3 Discussions

    0
    None
    sfcsarah

    9 years ago on Step 4

    by wrapping the cord into such tight knots, it only makes it more likely to break

    1 reply
    0
    None
    sfcsarahsfcsarah

    Reply 9 years ago on Step 4

    I think if you made the cord wraparound part much wider, it might be better.


    0
    None
    darklucifer

    10 years ago on Introduction

    nice will be perfect to hold my mums earphones my mum washed her set of these earphones in her jacket and then dried them in the dryer without knowing and they still work, no audio loss or crackling or anything like that.