Headquarter Industrial Desgin Pipe-Light

800

25

12

About: ...diY...

...so i found some inspiration on an industrial pipe wall design light / element

Step 1: Sketch Up

so i started to draw a plan on how it should look after

Step 2: Assembling

After some few hours i finally finished the assembling of all the fittings and valve etc

Step 3: Coloring

I added a primer to permit to spray after full assembling completed

Step 4: Wiring Up

after primer was dry i demountet some segments to permitt to wire it all up

Step 5: Finish

...finally spayed with black colour et voila finished work

Share

    Recommendations

    • Arduino Contest 2019

      Arduino Contest 2019
    • Trash to Treasure

      Trash to Treasure
    • Tape Contest

      Tape Contest

    12 Discussions