Introduction: Hello Everybody
This is a new lego race car design I made up.Hope you like it.
Step 1: Step 1
These are all the pieces.
Step 2: Step 2
First take the 2x8 plate and place it on the 4x4 plate.
Step 3: Step 3
Second place the 2 axle pieces on the model.
Step 4: Step 4
Place the 2 black pieces either side of the model.
Step 5: Step 5
Fourth place the 4 studs on either side of the black pieces.
Step 6: Step 6
Fifth place the yellow 1x4 on the side with the yellow 1x1 studs.
Step 7: Step 7
Put the 2 1x2 green plates on the other side.
Step 8: Step 8
Next put the 2x4 black plate on the bottom of the model. This will be the front.
Step 9: Step 9
Eighth put the 1x4 on the end of the 2x4 black plate.
Step 10: Step 10
Place the 2 transparent blue studs on the bottom of the white plate.
Step 11: Step 11
Next put the two clear slanted plates on the middle of the white plate. Then put the two orange 1x1 plates on either side of the clear slanted plates.
Step 12: Step 12
Place the 2 green fenders on the side with the green studs.
Step 13: Step 13
Next put the 2 yellow fenders on the other side.
Step 14: Step 14
Put one green 1x4 on the green side and another yellow 1x4 on the other side.
Next put 2 grille pieces on the front of the model
Step 16: Step 16
Next put the yellow 1x4 on the yellow side and the green 1x4 on the green side.
Step 17: Step 17
Put the 4x4 in the middle of the model.
Step 18: Step 18
Put the 2 windshield pieces on the 4x4.
Step 19: Step 19
Put the yellow 2x4 right behind the back windshield.
Step 20: Step 20
Put the 2 green 2x2 plates on the green side of the model.
Step 21: Step 21
Place the yellow 1x4 plate on the yellow side.
Step 22: Step 22
Put the grey 1x4 plate on the end of the model.
Step 23: Step 23
Put the green 1x2 on the green side and the yellow 1x2 on the yellow side.
Step 24: Step 24
Lastly put on all the wheels and you've finished.