Hexafish Rainbow Loom

69,985

32

11

About: Heeeelo friends and strangers alike. I am Dudespie, you can call me Dudes, or D if you wanna. I'm mostly doing Rainbow Loom instructables, or anything that has to do with Mlp. I might not be on that much, ca...

Intro: Hexafish Rainbow Loom

I will be using cray-Z-loom, any other loom works, be sure to have a lot of time on your hands when making this bracelet. Takes 6 pins.

Step 1: What You Need

For this activity, you will need a loom, a hook, and a LOT of rubber bands

Step 2: Placing the Bands

You will need 6 pins, place rubber bands around all 6 pins in a rhombu

Step 3: Layering

place another layer of bands of any color on top of The figure eights you made previously.

Step 4: Hooking

on each peg, hook the bottom 2 bands over. Your loom should look like the one in the picture. After this step, each peg should have 2 bands of the same color on it.

Step 5: More Layers

apply another layer of bands and repeat hooking the bottom 2 bands. Do this throughout your entire bracelet until finishing! Have fun!

Step 6:

Share

    Recommendations

    • Optics Contest

      Optics Contest
    • Electronics Tips & Tricks Challenge

      Electronics Tips & Tricks Challenge
    • Audio Contest 2018

      Audio Contest 2018

    11 Discussions

    OMG!!!!! I love this ❤️❤️❤️❤️❤️ Thank you soooooooooooooo much!!!!!!!

    0
    None
    ilovestages

    3 years ago on Introduction

    This is AWESOME! My friend just gave me one and I looked up how to make one and this is the only thing I found that was easy and understandable!

    0
    None
    Loom Rocker

    3 years ago on Introduction

    thank you because, i to was searching for a long time

    lovely colours

    just the thing i want !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

    0
    None
    ApekshaL

    4 years ago on Introduction

    thank you so much..... I have been searching for hexafish like forever.... I found many tutorials but all of them said you need to have a rainbow loom and not a cra-z-loom because you need to square them up.... i never knew you can make it on the cra-z-loom.... Thanks a Lot!

    0
    None
    DudespieDream_Wish77

    Reply 4 years ago on Introduction

    Hook all of the bands onto one peg. Then, stick your hook into all of the bands and pull them onto your hook. Put a c or s clip on them and wear! Still confused? Just tell me and I'll add it to this instructable.


    Thanks!
    -Dudespie