Home Made Signals by Paul Fast Post

Introduction: Home Made Signals by Paul Fast Post

home made signals by Paul Fast post

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Home Made Signals by Paul Fast Post

  1. HOME MADE SIGNALS by Paul Fast post
  2. ThESE SIGNALS HAVE BEEN MADE OUT BEZELS AND CARD AND WIRE AND OTHER BITS AND PIECES.

I SOLDERED THE wires to the bezels 2 wires to each bezel. Then I painted the wires red and green to match the bezel light.

I then made the signal head out of card, then painted black, then drilled holes the the card to accept the bezels.

The last photo is a signal gantry I made, using an old Bachmann signal gantry as the base.

On this one each green bezel has been joined to a red on the opposite side, so when the green signal shows a red signal will show on the other side.

Be the First to Share

    Recommendations

    • Backyard Contest

      Backyard Contest
    • Silly Hats Speed Challenge

      Silly Hats Speed Challenge
    • Arduino Contest 2020

      Arduino Contest 2020

    2 Discussions

    0
    tomatoskins
    tomatoskins

    4 years ago

    This turned out looking so good! Thanks for sharing you project!

    0
    paul Fast post
    paul Fast post

    Reply 4 years ago

    Thanks, I am glad you liked it.