Hot Wheels Plexiglass Ramp

903

9

3

Intro: Hot Wheels Plexiglass Ramp

Give some speed to your kids hot wheels.

Step 1: You Need

Two pine board
The glass from a Ikea Nyatt Frame
Some Tools

Step 2: Make It

After some tries I've got the right shape. Saw the first board, report on the other one and saw it two.

Step 3: Assemble

Take care plexiglass is very weak, do not tight to strong. Sharp the edges with sand paper.
Let's roll.

Share

    Recommendations

    • Audio Contest 2018

      Audio Contest 2018
    • Metalworking Contest

      Metalworking Contest
    • Tiny Home Contest

      Tiny Home Contest

    3 Discussions

    0
    None
    crapflinger

    4 years ago on Introduction

    as an improvement on the idea, if you were to route out a groove 1/4" from the curved edge you could just slide the plexi into the groove instead of using the screws which would help in reducing the chances of shattering the plexi, and it would also give you some nice track edges to keep the car in the lane so they don't spin out going down the ramp.

    1 reply