How to Dust for Fingerprints

31,256

31

10

Intro: How to Dust for Fingerprints

Ever wanted to find out who stole the cookie from the cookie jar? Take a page from crime scene investigators and get the proof you need.

You Will Need
  • A small or medium-size balloon
  • A lit candle
  • A powder makeup brush
  • Clear tape

Step 1: Step 1: Fill the Balloon Halfway With Water

Fill the balloon halfway with water from the tap. Remove from the faucet and fill the other half with air. Tie it off.

Step 2: Step 2: Hold the Balloon Over the Lit Candle

Light a candle. Hold the balloon at the knot end and dangle it above the flame, so the tip of the flame touches it. After 15 to 30 seconds, the smoke from the candle will collect as soot on the balloons surface.

Step 3: Step 3: Collect the Carbon Soot From the Balloon

Using the brush, collect some of the carbon soot from the balloon.

Step 4: Step 4: Brush the Soot Onto the Fingerprint

Brush the area you want to search for fingerprints, coating it lightly with soot. If you need more soot, hold the balloon over the flame again until you get enough soot to dust with.

Tip:
The smoother the surface, the better the fingerprinting results will be.

Step 5: Step 5: Identify a Fingerprint

Look for the patterns and swirls that identify a fingerprint. The oils in the print will make more of the carbon stick than the areas directly around it.

Step 6: Step 6: Collect the Fingerprint.

Once you’ve located a print and it’s covered in soot, place a piece of clear tape over it. When you remove the tape, the fingerprint will be stuck to it!

Share

    Recommendations

    • Audio Contest 2018

      Audio Contest 2018
    • Optics Contest

      Optics Contest
    • Electronics Tips & Tricks Challenge

      Electronics Tips & Tricks Challenge

    10 Discussions

    0
    None
    ejrandal7096

    1 year ago

    Now i know who has been in my room! :p

    0
    None
    J@50nJ@50n

    Reply 9 years ago on Introduction

    dident work to well for me but i dident have a make-up brush. does that affect it?

    0
    None
    jrdur7277

    9 years ago on Introduction

    is there any kind of software that i can use to read these fingerprints?

    0
    None
    the_mad_man

    9 years ago on Introduction

    you don't need a balloon to collect soot. you can do this on a piece of metal or something that woun't burn too readily.