How to Make 3D Printed Rack Gear Slider With RC Servo 9G SG90

Introduction: How to Make 3D Printed Rack Gear Slider With RC Servo 9G SG90

Description:

This is the 3D printed small rack gear slider. It is light and small, perfect for the small project which are involving in sliding, up and down lifter and else. The rack gear slider is controlled by Tower Pro Micro RC Servo Motor 9g SG90. The slider able to extend maximum 5 cm long and able to maintain certain extended length of slider. The rack gear can be attached easily to other hardware by locking the predesign M3 screw hole.

Specification:

  • Origin: Malaysia
  • Come with Tower Pro Micro RC Servo Motor 9g SG90
  • Rotation angle: 0 degree - 180 degree
  • Maximum extendable length: 5cm

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Material Preparation

Step 2: Drawing Design

Be the First to Share

    Recommendations

    • LED Strip Speed Challenge

      LED Strip Speed Challenge
    • Sculpting Challenge

      Sculpting Challenge
    • Clocks Contest

      Clocks Contest

    Discussions