Introduction: How to Make a Airsoft Sentry Gun
In the above video, I will be explaining how you can make your own airsoft sentry gun. I hope that you enjoy this video. If so, I would appreciate it if you gave it a LIKE!
- Arduino Uno
- 1K Ohm resistors (x2)
- Printed circuit board
- Red LED
- TIP120 Transistor
- 1N4004 Diode
- 6V battery pack (holds 4 AA batteries)
- 3 Pin Header (x3)
- Project box
- Any two high torque servos (I used a Hitec HS-5755MG and a S2008MG)
- Plentry of 16mm MDF or material of your choice
- L-Brackets (x2)
- Hardware (screws, bolts, nuts)
- Music stand or Tripod
- 1 1/4 wheels (x4)
- Gravity fed Airsoft gun
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Participated in the
Epilog Contest VII