How to Make a Car With Little Bits Controller by a Light Sensor

2,008

13

2

Introduction: How to Make a Car With Little Bits Controller by a Light Sensor

About: First year Mechatronics Engineering student. Imagination is more important than knowledge. #Tinkering

This is a fan controlller by a light sensor , in this case we're using a 9V battery for power , a light sensor for control the DC motor. This can use for kids that are tinkering and creative.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: The Materials for This Project

  1. The materials are:
  2. 9V battery
  3. Power module
  4. Battery cable
  5. Mounting board
  6. Elastic band
  7. Light sensor module
  8. DC motor module
  9. Fork
  10. Wheel(2)

Step 2: Connect the Cable to the Battery of 9V

We proceed to connect the battery of 9V for power the circuit.

Step 3: Connect All the Modules

We proceed to connect the module power to turn on the circuit , then we connect the light sensor module that it´s configured in light sensitivity ,next we connect the fork for be able to connect more things , in this case two DC motor.

Step 4: Mount the Circuit in the Board.

Once the board is mounted you can put it on different ways of your choice, be creative!!

DIY Summer Camp Challenge

Participated in the
DIY Summer Camp Challenge

Makerspace Contest

Participated in the
Makerspace Contest

Be the First to Share

    Recommendations

    • Finish It Already Speed Challenge

      Finish It Already Speed Challenge
    • Arduino Contest 2020

      Arduino Contest 2020
    • First Time Author Contest

      First Time Author Contest

    2 Discussions

    0
    emills05
    emills05

    Reply 3 years ago

    Thank!! , U can do too.