How to Make a Fan With Little Bits Accesories Controller by a Button

Introduction: How to Make a Fan With Little Bits Accesories Controller by a Button

About: First year Mechatronics Engineering student. Imagination is more important than knowledge. #Tinkering

This is a fan controlller by a push button, in this case we're using a 9V battery for power , a button for control the display and the speed of the fan . This can use in a hot room.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Materials for This Project.

The materials are:

  1. 9V battery
  2. Power module
  3. Button module
  4. Battery cable
  5. Fan module
  6. Display module
  7. Mounting board
  8. Elastic band

Step 2: Connect the Battery to the Cable

We proceed to connect the battery of 9V for power the circuit.

Step 3: Connect All the Modules

We proceed to connect the module power to turn on the circuit , then we connect the button module to change the speed of the fan ,next we connect the display module and put it in count up to increase the speed , and if you put in count down to reduce the speed and finally connect the fan module.

Step 4: Mount the Circuit to the Mounting Board

Once the board is mounted you can put ti on different ways of your choice, be creative!!!

Makerspace Contest

Participated in the
Makerspace Contest

DIY Summer Camp Challenge

Participated in the
DIY Summer Camp Challenge

Be the First to Share

    Recommendations

    • Backyard Contest

      Backyard Contest
    • Silly Hats Speed Challenge

      Silly Hats Speed Challenge
    • Arduino Contest 2020

      Arduino Contest 2020

    Discussions