How to Make a Remote Fire Starter!

3,802

23

3

Introduction: How to Make a Remote Fire Starter!

About: Your one stop place for electronics tutorials, components and services!

In this instructable I will show you How To Make A Remote Fire Starter!

watch the video!

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: What You Need

9 volt battery
Battery Clip
Switch
10 ohm resistor
Soldering iron
Solder
Hot Glue and gun

Step 2: Step 1

First, solder the red wire of the battery clip to the switch.

Step 3: Step 2

Now Hot Glue the switch onto the battery clip.

Step 4: The Resistor

No twist the resistor around the tip of the match.

Step 5: Fire!!!

Now connect the resistor to the battery and flick the switch!!

Thanks for reading please visit http://jackshow2s.weebly.com/

Be the First to Share

    Recommendations

    • Backyard Contest

      Backyard Contest
    • First Time Author Contest

      First Time Author Contest
    • Silly Hats Speed Challenge

      Silly Hats Speed Challenge

    3 Discussions

    0
    tarinno
    tarinno

    7 days ago

    How to make it become 10-15mins to ignite?

    0
    gm280
    gm280

    3 years ago

    Why the resistor? If you take one stand of most any stranded wire, you can make the exact same setup without any resistor. I have done it numerous times. But nice project anyway.

    0
    Jacks how2s
    Jacks how2s

    Reply 3 years ago

    The Resistor Is More Reliable Compared To The Resistor As Sometimes The Wire Heats Up And Snaps Off But The Resistor Is Always Going To Burn.