This project is an instruction of "how to use Segment 3642BH with Arduino via skiiiD

Before start, below is a basic tutorial for how to use skiiiD https://www.instructables.com/id/Getting-Started-With-SkiiiD-Editor/

Step 1: Launch SkiiiD

Launch skiiiD and select New button

Step 2: Select Arduino UNO

Select ① Arduino Uno and then click ② OK button

*This is Tutorial, and we use Arduino UNO. Other boards(Mega, Nano) have the same process.

Step 3: Add Component

Click '+' (Add Component Button) to search and select the component.

Step 4: Search or Find a Component

① Type 'Power' on the search bar or find the PowerLed 3W on the list.

Step 5: Select PowerLed3W

② Select PowerLed3W Module

Step 6: Pin Indication and Configuration

then you can see ③ pin indication. (You can configure it.)

*This module has 3 pins to connect

skiiiD Editor automatically indicate pin setting *configuration available

[Default Pin Indication for PowerLed3WModule] in case of Arduino UNO

S: 3

+: 5V

GND: GND

After configuring pins ④ click ADD button on the right below side

Step 7: Check Added Module

⑤ Added Module has appeared on the right panel

Step 8: SkiiiD Code of PowerLed3W Module

skiiiD Code is intuitive function-based codes. This is based on skiiiD libraries

on()

"Turn on the LED."

off()

"Turn off the LED."

toggle()

"Toggle. Switch turn on states to off or vice versa. \nBrightness will be applied when the LED turn on.(Brightness Range: 0 ~ 255)"

blink()

"Blink LED.\nVariable interval : Time interval between blink LED, default : 1,000ms\nVariable brightness : Change brighness of LED, default : 100(Brightness range: 0 ~ 255)."

fadeIn()

"Gradual increase the intensity of LED light during the time interval.\nVariable interval : Time interval until LED increasing the intensity to maximum, default : 1,000ms.\nVariable brightness : Change brighness of LED, default : 100."

fadeOut()

"Gradual decrease the intensity of LED light during the time interval.\nVariable interval : Time interval until LED increasing the intensity to minimum, default : 1,000ms.\nVariable brightness : Change brighness of LED, default : 100."