How to Make a Duct Tape Wallet

Introduction: How to Make a Duct Tape Wallet

These are the basic steps on how to make a wallet out of Duct Tape.
1 Roll of Duct Tape

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Making the Base

Cut 8 pieces of duct tape 7 in. long.

Step 2: Making the Base Part 2

Lay 4 of the pieces sticky side up and overlap them.

Step 3: Making the Base Part 3

Take the 4 other pieces and tape them on the other ones so there is no sticky side.

Step 4: Making the Base Part 4

Cut off extra scraps of duct tape. Fold in half. this is the base.

Step 5: Making the Base Part 5

Cut a piece 10 in. long, tear in half lengthwise.

Step 6: Making the Base Part 6

Seal the ends of the base with the tape. Cut off scraps of duct tape.

Step 7: Making the Pocket Base

Cut three pieces of 14 in. duct tape.

Step 8: Making the Pocket Base Part 2

Take two of the pieces and stick them back to back. This is the pocket base.

Step 9: Making the Pockets

Tear the third piece in half lengthwise.

Step 10: Making the Pockets Part 2

Take the last piece and stick it halfway over the pocket base and fold down the other side so it sticks.

Step 11: Making the Pockets Part 3

Cut four squares of the pocket base so they fit as pockets in the base.

Step 12: Making the Pockets Part 4

Tape the four pieces to the base the pockets face upward.

Step 13: Making the Pockets Part 5

Fold back in half so the pockets are on the inside or the outside.

Step 14: Taping the Sides

Tape the sides closed.

Step 15: Finishing the Wallet

Fold in half again and your wallet is done. You can decorate it if you want.

Be the First to Share


    • Finish It Already Speed Challenge

      Finish It Already Speed Challenge
    • First Time Author Contest

      First Time Author Contest
    • Leather Challenge

      Leather Challenge