How to Make a Beer Pong Ball Catcher




I thought these up while playing beer pong. My carpet isn't always the cleanest so I figured after it waas covered in beer and hitting the floor it wasn't the cleanest little thing and I didn't want to get a mouthful of cat hair. So, this is the result of that. Of course these catchers don't only have to be for beer. They could also be filled with juice or something for family fun!

Materials you will need:

2 x 2L Pop Bottle  (you need one per catcher, I play with 3 per side for mroe fun.)

1 Knife/Scissors

I hope you enjoy! Comments welcome.

Step 1: Materials

1. 2 Litre Pop Bottle
2. Cutter (knife/scissors)

Step 2: Make the Cut

Ignore my right finger, I was in a car accident and its kind of ugly ;)

What you want to do is use the top of the Cola bottles label as a guide.

Simply cut around the entire bottle.

Step 3: Voila!

That's that.. you have a beer pong ball catcher!

Thanks for reading my first instructable! More to come I'm sure!



    • Fat Challenge

      Fat Challenge
    • Pocket Sized Contest

      Pocket Sized Contest
    • Jewelry Challenge

      Jewelry Challenge

    5 Discussions


    8 years ago on Introduction

    I get the idea to keep it clean but this makes the cup much larger. Maybe use a smaller 710 ml container.

    1 reply

    Reply 6 years ago on Introduction

    yeah exactly! you can use the smaller 710mls or the 1Liter bottles as well. they are better for sure, harder target.


    Reply 6 years ago on Introduction

    the ball at parties.. goes in peoples dirty hands.. on the floor.. gets stuff on it.. it stops the ball from going into the drink itself.

    I think this is a stupid idea. It makes the cup bigger. If you're worried about cleanliness then you should play with water in your cups and a beer in your hand, just make sure to finish your beer before the end of the game. you'll have drank just as much beer as you would had you had beer in your cups.