How to Make a Duct Tape Wallet

About: I love Duct tape, The georgia bulldogs, and girls

Every single description of how to make a duct tape wallet.

Step 1:

Step one you make a strip that is 19 inches long. You want to make four of these just over lapping each other.

Step 2:

This is the four strips that are 19 inches and are face down at the moment.

Step 3:

Then you fold the duct tape in half from bottom to top and tape the sides together.

Step 4:

Once you have the sides taped together you can start working on the pockets.

Step 5:

make a strip a little bit smaller than half of the wallet.

Step 6:

Once you have this then tape this on to one half of the wallet so it is a card wallet.

Step 7:

This is what it should look like. Then make three other pockets, one below the first wallet and two on the other side.

Step 8:

once you made those four pockets you can add color to it. As you see it I used tie die duct tape and chrome duct tape.

Step 9:

You can also add color to the out side and make cool designs like I did. This is your finished project. I hope I helped.

Share

    Recommendations

    • Paper Contest

      Paper Contest
    • Organization Contest

      Organization Contest
    • Warm and Fuzzy Contest

      Warm and Fuzzy Contest

    3 Discussions

    0
    None
    westfw

    9 years ago on Introduction

    So where did you get the tie-dye duck tape? I thought it was still being voted on. (and your chrome looks nicer than what I've seen elsewhere too.)

    1 reply