Introduction: How to Make a Snowboard/Tramp/Carpet Board!
Heres how you turn a old skateboard into the following:
- A snowboard
- A trampboard (A wheelless skateboard that goes on a trampoline)
- Or a carpet board! (A board you use without wheels on carpet)
*PLEASE CLICK THE IMAGES MOST OF THEM DONT SHOW THE NOTES*
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: Getting Started!
You will need:
- A 5/16 wrench (i think thats what it is)
- Duct tape (Optional) (Any color/design)
- Scissors (Only needed if using duct tape)
- Screw driver (Not flathead)
- A old skateboard
Step 2: Removing Trucks/wheels!
Make sure to remove the nuts/bolts (I forgot what they are) And hold the screw so you can remove the Nuts/bolts and then pop out the screws and the washers (those little thingy under the nuts/bolts) Do this for both trucks
Step 3: Organizing!
Make sure to organize stuff so you dont loose pieces!
Step 4: Finishing Up
I had a giant crack in my skateboard, Used duck tape or else it would rip the trampoline and then yea :(
Step 5: Finished Product!
Heres what it looks like! You can always put the skateboard back together.
If your going to use this for snowboarding:
Wax the snowboard with snowboard wax!
*Snowboarding might be hard without feet handles, try making some! Or find a DIY Skateboard into snowboard guied and maybe it will have steps to create feet handles*
Tape isnt needed unless there are sharp/pointy edges!
Step 6: Riding on It!
Someone requested me on it, im using it on the trampoline.
If you wonderd what it looks like here it is!