How to Make One of Those Hole in One Games.

I've always wanted one of these games, but they are always just so damn expensive. So today, I'm gonna teach everyone who reads this how to make one. This is my first instructable, so it might suck;)

Step 1: Materials

You will need:
An 11x3in (28x7.5cm) Plank of wood about a half-an-inch thick.
A 3x3.5in (7.5x9cm) Plank of wood about a quarter inch thick.
A Carving Knife.
2 Metal Rods about 13 inches (33cm) long or longer.
A Golf Ball.
Super Glue.
4 Nails (or more).
Sharpie Pen (or other PERMANENT marker).
Felt (optional).

Step 2: Making the Main Parts

Carve six holes in the larger plank about the size of a golf ball, each about a little bit less than an inch apart. IMPORTANT: ALWAYS REMEMBER, MEASURE TWICE, CUT ONCE.

Step 3: Making the Main Parts, Cont.

Grab the smaller plank and measure 2.5 inches up and then carve a line about a quarter inch by 3in (3/4x7.5cm) the longer measurement being horizontal. AGAIN ALWAYS REMEMBER: MEASURE TWICE, CUT ONCE.

Step 4: Time to Assemble!

Now, attach the small piece (with nails) to the big piece, like an L. The 3in from the big to the 3.5in from the small.

Step 5: Inserting the Rods

Insert the remaining two nails at the opposite end of the larger plank, not the one attached to the smaller plank. Insert the rods into the slit in the smaller plank, and then super glue the left rod to the left nail, and the right rod to the right nail. Leave to dry as directed on box or bottle.

Step 6: SHARPIE TIME

Take your Sharpie (black recommended) and in this order from the smaller plank write (above the holes; hole-in-one, eagle, birdie, par, bogey, double bogey.