Introduction: Industrial Spool Chair
3x 36x1/2’’ Metal Rods
8x 36’’ Planks of wood (24ft in total)
6x ½’’ Metal Nuts
Step 1: Step 1
Remove the spool wheels from the connecting wood
Step 2: Step 2
´Drill 3 ½’’ holes, one at the base of the chair, one at the top, and one at the lower edge.
Cut out 8 more holes, in the formation of a chair seat, for wood later on
Step 3: Step 3
Prepare 836’’ planks of wood
Place the wood into the wood holes and 36’’ metal rods into the metal holes.
Step 4: Step 4
Tighten the wood on and sanding any sharp edges