Introduction: Installation of RJ45 Connector That Does Not Require Specialized Crimping Tool
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: Strip Cable Jacket
Step 2: Align Wires
Position wires in the slots of the load bar according to desired wiring scheme, the color coding of T-568A/B wiring are labelled on the side of the load bar
Step 3: Trim Excess Wires
Step 4: Close the Load Bar And... DONE!
The wires are connected by the IDC terminals as the load bar is closed.