Interfacing Accelerometer ADXL 335 With Mediatek LinkIt One Board

Introduction: Interfacing Accelerometer ADXL 335 With Mediatek LinkIt One Board

Using Mediatek LinkIt One You will be able to interface ADXL 335.

The ADXL335 is a small, thin, low power, complete 3-axis accelerometer
with signal conditioned voltage outputs.

Step 1: Components

ADXL 335 : Accelerometer Sensor
Mediatek LinkIt One Board
Connecting Wires
BreadBoard

Step 2: Connections

VCC : 3.3V On Board
GND :Ground
X_OUT: A0
Y_OUT: A1
Z_OUT :A2

Step 3: Code,Compile and Run

Upload the code and now you can see the Output on the Serial Monitor.

Thank you watching this!!

Be the First to Share

    Recommendations

    • Pocket-Sized Speed Challenge

      Pocket-Sized Speed Challenge
    • Super-Size Speed Challenge

      Super-Size Speed Challenge
    • Audio Challenge 2020

      Audio Challenge 2020

    5 Discussions

    0
    ehudwill
    ehudwill

    4 years ago

    Tried your code with my Linkit One but all I get is a reading on my y-axis. Very little reading at that. Any suggestions?

    Screen Shot 2016-01-19 at 9.26.35 PM.png
    0
    frankdark
    frankdark

    4 years ago

    can i use it on the arduino Uno??
    :) and where can i see the output??
    i mean that COM6 GUI??

    0
    VaibhavK18
    VaibhavK18

    Reply 4 years ago

    Yes! You can use it on arduino uno and the output will be displayed on the serial monitor!

    0
    frankdark
    frankdark

    Reply 4 years ago

    what is serial monitor? :)
    sorry 1st timer on arduino.

    0
    VaibhavK18
    VaibhavK18

    Reply 4 years ago

    It is present in the arduino ide which helps us to observe output of the interfaced sensor respectively!