SD Card Carrier

If you own a 3d printer or a raspberry pi and need a way to hold your SD cards in a presentable manner you should look no further than this instructable.
The SD card holder is a project that i made so i could easily store my SD cards.
I used a laser to cut and details the wood .The magnet is a .25 x .0625 in magnet that go half way through the wood. The magnet also has a tight fit in the wood and does not come out. The case is made of three layers: the top is the cover; the middle is the  holding frame; the final piece is the bottom.


Cyan: outside borders

Green: cut half way through the wood for the magnet

Red: fine details

Created for imperial measurements

Thing needed:

Wood
Screw
..25 x .0625 inch magnets
laser

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Organization Contest

Participated in the
Organization Contest

Be the First to Share

    Recommendations

    • CNC Contest

      CNC Contest
    • Make it Move

      Make it Move
    • Teacher Contest

      Teacher Contest

    Discussions