Invisible Cd Shelf

Introduction: Invisible Cd Shelf

Cd Shelf Levitation !


Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: What You'll Need


4 cd case
Medium sized "T" Bracket
Carpet Knife
Pen
wood screws
Epoxy Glue


.
Use Cd case you don't use again

Step 2: Cut and Measure


Measure the middle way point, make a mark, set down your bracket, draw an outline, measure again, cut out a hole deep enough that the bracket will set flush. You are doing this to the inside bottom of the Cd.Stick the bracket with epoxy glue.Make a slut on the top of the cover for closing the case.Insert the cd paper in the case for hidding the bracket.

Step 3: Hidding Bracket Part

Take 2 cd case and make a slit on both side.And take 1 cd and make a slit only on the bottom.Glued the 3 cd together.This part will hide the bracket and allow you to replace the shelf on other place .

Step 4: Enjoy !

mount your new invisible cd shelf on your desired wall.This cd shelf are a very cool and easy project .

Participated in the
Discover Green Science Fair for a Better Planet

Be the First to Share

    Recommendations

    • Toys and Games Challenge

      Toys and Games Challenge
    • Backyard Contest

      Backyard Contest
    • Silly Hats Speed Challenge

      Silly Hats Speed Challenge

    12 Discussions

    0
    mrjubjub
    mrjubjub

    11 years ago on Introduction

    too bad no one really uses cd's anymore : (

    0
    xrobevansx
    xrobevansx

    12 years ago on Introduction

    what was the point of the second stack of dummy cd cases? Also- it holds like 5 cds? What's the point? I have 1000 or so that need to be stacked...Won't work for me, but nice instructable.

    0
    Uru Wolf
    Uru Wolf

    Reply 11 years ago on Introduction

    You could have two "guide" bars hanging from the roof, so it looks like the CD's are just held between them.

    0
    RecyclingMaker
    RecyclingMaker

    Reply 12 years ago on Introduction

    For hidding the bracket.And you can stack over than 100 cd with no problem.

    0
    killerjackalope

    This could have been done without the T-bracket bending, a simple set of L brackets, turned sideways would mount up very well and be a little sturier since the cases are weak in the middle, apart from being very similar to the invisible bookshelf, not bad.