Jewelry Box

Introduction: Jewelry Box

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Anti-scraping Bottom

I traced around the base of the box with pencil onto paper. Then i measured in 8mm so it wasnt showing when i stuck the felt on. And then i cut the paper stencil out and cut the felt out. And then glued it on with timber glue.

Step 2:

Step 3:

Step 4:

Step 5:

Step 6:

Step 7:

Step 8:

Step 9:

Step 10:

Step 11:

Step 12:

Step 13:

Step 14:

Jewelry Contest

Participated in the
Jewelry Contest

Be the First to Share

    Recommendations

    • Sculpting Challenge

      Sculpting Challenge
    • 3D Printed Contest

      3D Printed Contest
    • Motor Vehicle Contest

      Motor Vehicle Contest

    2 Discussions

    0
    thomasscholar
    thomasscholar

    6 years ago

    Thanks. I was going to over time fill in the blanks. Cos i sorta just made it to give to my girlfriend. So i have to backtrack and put the steps in. I dont own power tools. So its all done by rasps, screw driver, sand paper (lots and lots of sand paper) and a half blunt haxsaw saw.

    0
    audreyobscura

    nice work! mind including a little text for guidence? your pictures are clear, but it would be nice to have an additional explanation of how you made this.

    Keep it up!