Introduction: Kinects Wachusett Mountain Lion
This is the final product, Wachusett Mountain Lion
you will need
12 white 8 way connectors
2 gray one way connectors
8 green 4 way connectors
16 green sticks(very small)
12 white sticks(small)
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: Making the Legs
these are the four legs of the mountain lion
-8 green connectors (2 for each leg)
-8 white rods (2 for each leg)
Step 2: Making the Body
This is the body of the Wachusett Mountain Lion
-10 green rods
-8 white connectors
Step 3: Connecting the Body to the Legs
Connect the legs to the body by connecting each leg vertically into the white connector, do this for each leg , for the front legs do it at the very two front white pieces. For the hind legs use the back two white pieces.
Step 4: Making the Head and Neck
this is the head of the Wachusett Mountain Lion.
-4 white connectors
-6 green rods
-4 white rods
-2 gray one sided connectors (these will be used to attach the head into the body
Step 5: Connecting the Head to the Body
slide the two rods into the circular holes of the white connectors on the front of the body. once these are slid into place use the two one way gray connectors on the end of the white rods as shown
Step 6: Final Product
your design is now finished