K'nex Display Stand

Introduction: K'nex Display Stand

About: I like K'nex.

Hello fellow humans.Here is the part list to this amazing instructable!!!

Rods:

Green:64
Blue:4
Yellow:3
Red:2

Connectors

Red (3):4
Yellow (5):6
Grey (3D):8
Orange (1):33

Other:

Y (Connector):9

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Base

1.Build as shown.
2.Add 3 Y connectors on each side (6)

Step 2: Body

1.Build as shown.
2.Build as shown.
3.Gather 2 blue rods.
4.Connected as shown.
5.Connected as shown.
6.Connected as shown.

Step 3: Layer

1.Get 3 yellow rods and put 3 Y connectors at the end.
2.Make a so. (x11)

Step 4: Putting All Together

1.Put all yellow rods threw all orange connecters to make the layer.
2.Gather the base & body.
3.Put together base & body as so.
4.Connected the layer with the base & body.
5.Add three Y connectors at the back.

Step 5: Finished

Congratulations you have made your own K'nex Display Stand!!! Well Done.

Be the First to Share

    Recommendations

    • Cardboard Speed Challenge

      Cardboard Speed Challenge
    • Indoor Plants Challenge

      Indoor Plants Challenge
    • Sculpting Challenge

      Sculpting Challenge

    2 Discussions

    0
    OZKNEX22
    OZKNEX22

    6 years ago

    I like it! Good Work ;)