Knex Franchi Spaz 12

This gun was made by BlackShadow12, all credit goes to him for the design.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Non Working Pump

Step 2: Barrel and Body

Step 3: Stock and Stock Attachment

Step 4: Magazine, Handle, and Mag Pusher

Step 5: Trigger and Ram Rod

Step 6: Non Functional Flash Light

Step 7: Assembly

Step 8: Credit to Black Shadow 12

Be the First to Share

    Recommendations

    • CNC Contest

      CNC Contest
    • Teacher Contest

      Teacher Contest
    • Maps Challenge

      Maps Challenge

    16 Discussions

    0
    None
    dynamite_kid

    2 years ago

    your gun itself is good though

    0
    None
    dynamite_kid

    2 years ago

    you do know that you could have used a green conector insted of the broken yellow connector

    0
    None
    grimmjowking

    6 years ago on Introduction

    all the broken rods can be replaced with either yellow or blue rods

    It's pretty good. I think it has some edges that need to be cleaned up, and some editing that needs to be done, but other than that, good job.

    0
    None
    JonnyBGood

    6 years ago on Introduction

    Cool Gun! I think I'll build it just because I think I can dodge the broken pieces, except that pump will be a bit difficult.