Introduction: Knex Gun
An old gun that i never posted. I don't like it very much.
Everything is bad about it.
Small handle and weak frame.
Uses one cut piece. :(
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: The Handle
The handle. Same as always.
1. The handle
4. Put step 3 onto step 2 as shown
5. Add the little one in the middle
6. Add the last side onto it. Don't forget tape
Step 2: The Barrel
1. The barrel
7.- 10. Put on as shown
Step 3: The Trigger
Trigger. Easy peay
2. Build form the pictures
3. Reffer to picture 1 for assembly.
Step 4: Assembly
1. Add the trigger
2. Cover it up
3.Put it on the gun
5. Put it in
6. Put a rubber band on the trigger
7. Put rubber bands onto the ram