Knex Nerf Disc Holder

Introduction: Knex Nerf Disc Holder

This is my very easy to do Knex Nerf Disc Holder. It takes about 5 minutes to do and it only uses 24 pieces.

It is also adjustable to the number of discs you have.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Parts

You only need 24 pieces to complete this:

2 Rods of any size you want (to accommodate the number of discs you have)

4 Orange or Brown Connectors

4 Yellow or white connectors

8 White or gray small rods

6 Tan or blue connectors (Do not necessarily have to have the stem cut off)

Step 2: First Step

Get the 4 Yellow or White Connectors and the small white or gray rods.

Put them together like the pictures shows.

Step 3: Second Step

Now connect the orange or brown connectors to the small rods as shown in the picture.

Step 4: Third Step

Now add the other rods (of any size) to the middle hole of the two parallel connector and then sap te other rod on the last connector of the connector.

(I even confused myself while typing this step)

Step 5: Fourth Step

Add the small connectors to both ends of the long rod.

Step 6: Final Step

The final step is to add two small connectors to the inside of whatever side you want and push that side all the way to the end of the rod.

Step 7: Finished Product

The cool thing about this is that it is adjustable. This is of my own design so i'm proud of it.

This is my first Instructible, So if you see something that i could improve on please comment below.

Thank You

Be the First to Share

    Recommendations

    • Trash to Treasure Contest

      Trash to Treasure Contest
    • Rope & String Speed Challenge

      Rope & String Speed Challenge
    • Fix It Contest

      Fix It Contest

    3 Discussions

    0
    The_Spaniard
    The_Spaniard

    Reply 3 years ago

    Thank you