Knex RW1

About: Knex builder here at Instructables. I build Guns, and, Roller Coaster. I currently build about 2-3 guns a month. I strive to post quality as well as quantity. If you have any ideas for a gun for me to try ou...

Hello friendly stalkers of knex, and this is my new knex RW1 from advanced warfare. When this gun is used right, it's a beast. From all the cods and battle fields I've played this is the first one shot pistol I've ever used. This thing a a monster sniper with the stock chopped off and is break action. If you unlock the rail driver people get chill bumps when you join lobby number 38 of 50. lol that's it for my epic intro. Before you all start, I know there are some aspects of this that are not correct. Ex the trigger guard needs to be longer, but the barrel has to be able to drop down meaning the trigger guard has to be pushed back a bit.

50-60 ish feet
Super duper comfy handle (finally found me a handle that is sturdy and comfortable)
For the most part looks right
Realistic break action
Decent pin pull
Shoots high at close range
I could not use paneling on the back portion of the gun

So that's it and remember to leave some
Feedback in da comments below, or above if your stuck on the stupid IOS app that doesn't have a reply button.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: With Scope

I had a request to make a scope for this but it's not much compared to the gun its self.

Be the First to Share


    • Book Character Costume Challenge

      Book Character Costume Challenge
    • Made with Math Contest

      Made with Math Contest
    • Multi-Discipline Contest

      Multi-Discipline Contest

    19 Discussions


    4 years ago

    your guns are so cool! I've been looking at a few if them and I've followed. Thanks for following me :D I will add it to my profile :-)


    4 years ago

    The scope looks a bit like the ACOG. Make the actual rw1 scope.


    4 years ago

    Looks pretty cool!

    Thanks, the break action works very well. The only thing with it is sometimes when you shoot, the barrel comes unsnapped from the joint thing and the barrel falls down like you do to reload it and makes the bullet hit the ground much sooner. It happens very little though.


    4 years ago on Introduction

    Love it, you got it perfect, the handles a little of, but it took me a while to notice.

    Great job!


    4 years ago on Introduction

    Your version is prettier than the original, I really like the look of the end of the barrel.


    4 years ago

    got internals or a full set of instructions?


    4 years ago

    I love it! Good job as always. I don't care that much for the looks, but the gun you modeled was not pretty to begin with. I'm sure it is fun to shoot, break action rules. :D

    3 replies

    Reply 4 years ago

    Oh, about the trigger guard, it isn't that bad. Those can be pretty tricky. It would look interesting with a scope.

    Lucas The BossCorgiCritter

    Reply 4 years ago

    Thanks, there is a professional version I have on aw that comes with a scope and looks epic. I try to make my replicas original, my IMR was the first replica I built that was not original. I might add a scope and put it in a separate step.