Knex SlingBow




Kind of a Slingshot but kind of a bow/crossbow.

Step 1: Handle

Build the handle. 12 orange connectors and 4 yellow rods.

Step 2: Main.

Build the main part of the Sling.

Step 3: Part 3

Add 4 orange connectors.

Step 4: Add Parts Together.

Add the handle and main part together,dont worry if it bends its ok.

Step 5: Part 2

add in the parts seen here.2 yellow connectors 8 gray small connectors,4 blue rods,4 red connectors and 2 orange connectors.

Step 6: Step 6

this is how the blue rod will connect to the orange connectors thats to to the right and left of the main part of the slingshot.u ned 4 gray connecters inbetween the blue rods on each side.

Step 7: Step 7

add the red rods to the yellow connectors that go on the main part of the slingshot and add the other peices shown in the pic.

Step 8: Step 8

add the orange connectors onto the red rods to reduce the bend of the sides.

Step 9: Step 9

add the rubberband like shown, and on the side that u want to shoot it out of pull the rubberband under the yellow peicem so it doesnt interfere with the firing.

Step 10: Finished

And there is your bow,this is how to fire it.The gray rods work best.And your supposed to hold it with one hand and pull it back with the other but i couldn't take a pic of it if i did that.



    • Epilog X Contest

      Epilog X Contest
    • Sweet Treats Challenge

      Sweet Treats Challenge
    • Paper Contest

      Paper Contest

    11 Discussions


    7 years ago on Step 5

    I was wondering if it really only needs 2 orange connectors or if you meant 4

    1 reply
    the commentor

    11 years ago on Step 2

    It's kinda okay, but can you make the pics a bit clearer?


    11 years ago on Introduction

    See i messed up on the handle so if you pull back to far it breaks wich reduces the ammount it can go.I only shot it in the house.dont wanna lose the peices ;)