Introduction: Knex Supertruck
This is what I like to call super truck
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: The Chassis
You first need 5 large gray rods. Then attach a wight connecter diagonally as shown above. Then build the axle by taking a long gray rod and putting a gray connector then a weel then a locking conecter as above then add the suspension. Then put the moter on and repeat the same as done on the other side. And than build the rear axle and attach it as shown.
Step 2: The Cab
Build the cab as shown.
Step 3: The Wing
Build the wing as shown