Knex Tank



Here is how you make the knex tank. so........................................... GET BUILDING!!!!!!!!!!!!!!!!!!!!

Step 1: The Body

Here is how you make the body.

Step 2: The Gears

Here is how you make the set of gears.

Step 3: Put Together

Here is how you put it together.

Step 4: The Chain

Here is how you make the chain

Step 5: The Mover in Front

Here is how you make that mover in front.

Step 6: Your Done!!!!!!!!!!!!

You are finally done!!!!!!! The tank likes to go over a big mound of knex rods but dosn't like to go on tile and slippery surfaces like that. You also need to use the motor in picture 3. If you flip over the tank it can also serve as a mini conveyor belt. That is what it was before until I found out it could be a tank. That's why it looks so bad. You don't need to use the red 90 degree pieces on the tracks. Enjoy!!!!!



    • Cardboard Challenge

      Cardboard Challenge
    • Warm and Fuzzy Contest

      Warm and Fuzzy Contest
    • Epilog X Contest

      Epilog X Contest

    7 Discussions


    8 years ago on Introduction

    this looks so bad because it used to be a conveyor belt and then i changed it


    8 years ago on Introduction

    Aside from looking horrible, it looks VERY functional, and is worth a good 4 *.
    Good work.