Knex "Wheel of Chance"

Introduction: Knex "Wheel of Chance"

About: DIY FTW! I love 3D printing, arduino, and anything you can make yourself.

This is a good "companion" to my knex plinko I had also made (https://www.instructables.com/id/Knex-Plinko/) as in my Price is Right mode. The wheel was a pain--fitting all those orange connectors-- but you can stick numbers for points on it. I created a base stand and with it, a rod that hits the flexis on the wheel. If you want (and can) you can take the wheel off, turn it horizontally, and make it the wheel of fortune!

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Hurricane Lasers Contest

Participated in the
Hurricane Lasers Contest

Be the First to Share

    Recommendations

    • Tiny Speed Challenge

      Tiny Speed Challenge
    • Spring Cleaning Challenge

      Spring Cleaning Challenge
    • Trash to Treasure Contest

      Trash to Treasure Contest

    6 Discussions

    0
    amazingness
    amazingness

    7 years ago on Introduction

    Great Job!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

    0
    KGuy
    KGuy

    Reply 7 years ago on Introduction

    Thanks again dude. :)

    0
    Sorunome
    Sorunome

    7 years ago on Introduction

    Haha, nice and simple :D
    (and get used to stuff that takes ages to make (referring to image note 'this was horrible'))

    0
    KGuy
    KGuy

    Reply 7 years ago on Introduction

    Yeah, I'm used to it--just joking around.