Knex Gun Stand

Introduction: Knex Gun Stand

I made a gun and then built this stand. It is simple and uses few parts.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Part Count

Grey: 6
Blue: 8

Yellow OR orange: 8
Grey: 4
Combine the blue and purple parts.

Step 2: The Base

Connect the grey and yellow rods to the blue+purple parts.

Step 3: Supports

Connect the blue rods to a yellow or orange connector on either end. 

Step 4: Finished

Combine the parts. I should not have to tell you how to do this.

Step 5: Tips

1. Put the but of your gun on the blue end.
2. You can add grays to lengthen the stand.
3. You can change the grey rods for any other.
4. Any extra pieces should be used as supports. 

Be the First to Share


    • Wearables Contest

      Wearables Contest
    • Fix It Contest

      Fix It Contest
    • Wearables Contest

      Wearables Contest



    6 years ago on Introduction

    Nice and simple although the instructions are hard to follow because the pictures are quite small but overall, great job! :-)