Introduction: K'nex IPod Nano (5gen) Stand
This is a great ipod stand.
uses very few pieces
all smooth so ipod doesn't get scratched
turning bar so ipod doesn't fall out
Step 1: Pieces
You need:
Conectors:
4 circle
2 green
7 red
14 yellow
1 orange
6 blue caps (optional)
1 Y
Rods:
18 small green
2 white
4 blue
4 yellow
2 red
Step 2: Step 1
Make 7 of these.
Step 3: Step 2
Make 2 of these.
Step 4: Step 3
Snap every thing on a yellow rod.
Read the notes
Step 5: Step 4
Read the notes
Step 6: Step 5
read the notes
Step 7: Step 6
Guss what?
Read the notes.
Step 8: Step 7
Yet again read the notes
Step 9: Finished
You finished!!!!!
Now put your iPod in.
Don't forget to rate 5* and subscribe!