Knife Handle Gluing Press

Intro: Knife Handle Gluing Press

This instructable is a followup to the instructable I put up a few days ago, detailing on how to make a knife. In that instructable I used a gluing press, and this is the instructable for how to make said press.

For this instructable you will need:

Materials:

Wood, thick plywood would be preferred.
Threaded rod, also called allthread
Threaded inserts
Thin walled pipe
Nuts, including wing nuts
Rubber

Tools:


Wood and metal saw, a hacksaw works fine
Hammer
Files

Drill, and drill bits
Knife


Hope you enjoy the instructable! Stay tuned for more stuff from Switch & Lever

Share

    Recommendations

    • Plastics Contest

      Plastics Contest
    • Audio Contest 2018

      Audio Contest 2018
    • Electronics Tips & Tricks Challenge

      Electronics Tips & Tricks Challenge

    3 Discussions

    0
    None
    calskin

    3 years ago on Introduction

    Thanks for sharing this. Do you think in the future you would fasten the pommel to the tang, or did this work out fine?

    1 reply